Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)S

Simon_C

@ Simon_C @forum.guncadindex.com

Posts
3
Comments
13
Joined
3 mo. ago

  • Fancy Molasses AR-15 grip

    Jump

  • I may do some of that in the future, yeah. I've had no complaints about durability yet, so fingers crossed.

  • Fancy Molasses AR-15 grip

    Jump

  • Backstrap Molasses AR-15 Grip NOW LIVE!

    Jump

  • Backstrap Molasses AR-15 Grip NOW LIVE!

    Jump

  • Beta testing is going well. Will launch shortly.

  • AUGtism Cope Grip

    Jump

  • "Cope" is literally in the name, dude.

  • AUGtism Cope Grip

    Jump

  • And this is pennies worth of filament that you can slap onto the AR-15 you already have.

  • AUGtism Cope Grip

    Jump

  • General Discussion @forum.guncadindex.com
    Simon_C

    AUGtism Cope Grip

    I decided to make an AR-15 grip for people who can't afford Steyr AUG's. Beta test soon.

  • Backstrap Molasses AR-15 Grip NOW LIVE!

    Jump

  • I just printed the prototypes with plain old PLA. ASA should work fine.

  • Backstrap Molasses AR-15 Grip NOW LIVE!

    Jump

  • I'm not quite sure the exact procedure people use on this website, to be honest. If you're on the deterrence dispensed chat, the beta files are already up there

  • Backstrap Molasses AR-15 Grip NOW LIVE!

    Jump

  • Thank you!

  • What types of weapons would you like to see more of?

    Jump

  • Were I in a jurisdiction that allowed it, I'd probably make a DIY blowback pistol in .380 ACP (including barrel and slide).

  • Backstrap Molasses AR-15 Grip NOW LIVE!

    Jump

  • Active Beta Projects @forum.guncadindex.com
    Simon_C

    Backstrap Molasses AR-15 Grip NOW LIVE!

    Hey everyone,

    I've got a grip design that's ready for beta testing.

    It is only ~10 degrees off from perfectly vertical, so the hole for the grip screw would normally end up right in the middle of the backstrap. To get around this, I made the backstrap a separate component that is pressed into the front of the grip after being screwed onto the receiver. This also allows you to easily make the grip two-tone or potentially print the rear in a firm rubbery material for extra comfort.